1
Voltage Gate
PASSDevice output type must match generator output.
120V required -> 120V available
Can the SOLIX C800 Plus Run a Washing Machine? It Depends on Your Model
1 of 3 models are compatible with this generator.
Jump to model-specific results ↓Power Margin Analysis
1200W / 1600W Capacity Running 180W to 291W short by model
1380W to 1491W required
Surge 109W to 220W headroom by model
1380W to 1491W required
Decision Gate Waterfall
Same decision gates as the engine: voltage, running, surge. Runtime is shown as operational context.
2
Running Gate
FAILContinuous draw with safety buffer applied.
1,380W to 1,491W required -> 1,200W available (180W to 291W short)
Required 1,380W to 1,491W required
Available 1,200W
3
Surge Gate
PASSStartup peak with safety buffer applied.
1,380W to 1,491W required -> 1,600W available (109W to 220W headroom)
Required 1,380W to 1,491W required
Available 1,600W
4
Runtime Insight
INFORuntime context only. It does not change the electrical compatibility verdict.
Continuous estimate: 0.4h
Device profile reference: up to 1h per day.
Power bars show required versus available output for each gate.
View full compatibility reportDecision Snapshot
Quick compatibility, required headroom, and model-specific context at a glance.
⚡
1200W
Running Power
🔋
768Wh
Capacity
⏱️
~0.4h
Est. Runtime
☀️
300W
Solar Input
Quick Compatibility Check
- 1 1 of 3 models are compatible with the SOLIX C800 Plus.
- 2 Model requirements range from 1200W to 1296W running watts.
- 3 See the model-specific results table for per-model verdicts.
Model-Specific Results
1 of 3 models are SAFE or TIGHT. Most demanding model: Whirlpool WTW8127LC (Top Load, 10.8A, 2-in-1 Agitator) (1,296W surge).
| Model | Running | Surge | Verdict | Runtime | Source |
|---|---|---|---|---|---|
| LG WM4000HWA (Front Load, 10A, Inverter Direct Drive) | 1,200W | 1,200W | Tight | ~0.4h | Engineering Est. |
Show expert analysisTechnical: **Running load:** 1200W from OEM specs (10A × 120V). **Surge:** 1200W modeled (no OEM startup current published — inverter direct drive uses electronic ramp-up with minimal inrush). **Voltage:** 120V AC. Front-load design with inverter direct drive motor (no belt), TurboWash 360. Field note: The WM4000HWA is the most power-station-friendly washer in this set. Front-load design uses less water than top-load, and the inverter motor starts smoothly without a power spike. For maximum battery life, use cold wash cycles — the internal heater is what drives the 10A peak draw. Can a portable power station run the LG WM4000HWA? Only if your power source can supply at least 1200W continuous at 120V. The inverter motor has no significant startup surge. Cold wash cycles draw less than the 1200W maximum. | |||||
| Whirlpool WTW8127LC (Top Load, 10.8A, 2-in-1 Agitator) | 1,296W | 1,296W | Fail | — | Engineering Est. |
Show expert analysisTechnical: **Running load:** 1296W from OEM Dimension Guide (max amp draw 10.8A × 120V). **Surge:** 1296W modeled (no OEM startup current published). **Voltage:** 120V AC. Top-load design with 2-in-1 removable agitator, 5.2-5.3 cu. ft. capacity. Note: the 15A circuit requirement is the minimum breaker size, not the appliance draw. Field note: The WTW8127LC is Whirlpool's current best-seller with the innovative 2-in-1 removable agitator. At 10.8A max draw it needs a power station rated for at least 1296W continuous. The OEM Dimension Guide clearly distinguishes 15A circuit requirement from 10.8A actual draw — a common source of confusion when sizing generators. Does the Whirlpool WTW8127LC really draw 15 amps? No — 15A is the minimum circuit breaker size, not the actual draw. The OEM Dimension Guide lists max amp draw at 10.8A (1296W). This distinction matters when sizing a power station. | |||||
| Maytag MVW7232HW (Top Load, 10.8A, Extra Power) | 1,296W | 1,296W | Fail | — | Engineering Est. |
Show expert analysisTechnical: **Running load:** 1296W from OEM Dimension Guide (max amp draw 10.8A × 120V). **Surge:** 1296W modeled (no OEM startup current published). **Voltage:** 120V AC. Top-load design with Extra Power button for stain pretreatment, deep fill option. Note: the 15A circuit requirement is the minimum breaker size, not the appliance draw. Field note: The MVW7232HW is Maytag's popular mid-range top-loader, built on the same Whirlpool Corp platform as the WTW8127LC. At 10.8A max draw it's electrically identical to the Whirlpool — the differences are in wash features (Extra Power stain pretreat) and brand positioning (Maytag = durability focus). Is the Maytag harder to run on a power station than the Whirlpool? No — both draw 10.8A (1296W) maximum. They share the same Whirlpool Corp motor platform. Any power source that runs one will run the other. | |||||
How This Pairing Performs Across Our Database
This unit is outside the compatible set; 23 of 33 generators pass SAFE/TIGHT for this device.
How Washing Machine Performs Across 33 Tested Generators
23 of 33 generators are SAFE+TIGHT for Washing Machine.
23
Safe+Tight
Safe 23 (70%)
Fail 10 (30%)
Power Comparison: Anker SOLIX C800 Plus vs Top Alternatives for Washing Machine
Anker SOLIX C800 Plus Fail
Current unit
Running 1,200W
Surge 1,600W
Fit class uses buffered needs (running and surge) for this device.
Specs & Surge Analysis
Large Appliances
Washing Machine
Laundry Day
Select Your Model:
1296W
Running
1296W
Surge
120V
Required
True Surge™ Analysis
Safety Buffer: +15% Running Power Usage 115% to 124% Utilization
1380W to 1491W required 1200W Capacity
180W to 291W short by model
Surge/Startup Peak 86% to 93% Utilization
1380W to 1491W required 1600W Capacity
109W to 220W headroom by model
Voltage Match 120V ↔ 120V ✓
Startup Surge Visual
Startup Surge
Washing Machine vs SOLIX C800 Plus
Startup surge stays within the power station surge limit.
Compare Similar Units
Free Tools
Station Tools
Generator Insights
The 1600W surge rating can support startup sequences for refrigerator compressors, well pumps, and similar inductive motor loads that draw 25 to 33 percent over running current during initial engagement. Once running, the 1200W continuous output can handle typical kitchen appliances, electronics, and power tools within rated limits. This combination addresses both inrush events and sustained runtime needs in backup scenarios.
This unit uses LFP chemistry, a battery architecture chosen for thermal stability in consumer power stations. The 768Wh capacity and 1200W continuous output allow sustained operation without thermal stress under typical residential loads. Source: Anker SOLIX C800 Plus Tech Specs (manufacturer documentation).
Extend Runtime with Solar
Keep your Washing Machine running with solar • MPPT: 11– 60V • Max: 300W
Official Anker
100W Panel
1 Hour Sun =
+0.1h per sun hour
MC4 -> XT60
Full in ~11h Adapter required: MC4 -> XT60.
Smart Value Bluetti
200W Panel
1 Hour Sun =
+0.1h per sun hour
MC4 -> XT60
Full in ~5.5h Adapter required: MC4 -> XT60.
Smart Value BougeRV
200W Panel
1 Hour Sun =
+0.1h per sun hour
MC4 -> XT60
Full in ~5.5h Adapter required: MC4 -> XT60.
Technical Analysis
Spec-Based • No GuaranteesTechnical Breakdown
Running range: 1200W (10A front-load) to 1296W (10.8A top-load) depending on design. Surge: modeled equal to running watts (no OEM startup current published for any model — modern washers use electronically controlled motors with minimal inrush). Voltage: 120V AC for all US residential models.
Expected Behavior
Estimated runtime: ~0.4h. Washing machines cycle through fill, wash, rinse, and spin phases over 30-60 minutes. Peak draw occurs during wash agitation and high-speed spin. Front-load models use less water and energy per cycle than top-load models. At 1 hour daily use, energy consumption ranges from 1200 to 1296 Wh.
Field Note
Modern washing machines are easier on power stations than their reputation suggests. Electronically controlled motors eliminate the brutal startup surges of older induction motors. The real variable is water heating: front-load models with internal heaters (Steam/Sanitize cycles) peak higher than top-load models that draw hot water from your plumbing. Use cold wash to minimize battery drain.
Frequently Asked Questions
Can the Anker SOLIX C800 Plus power a Washing Machine?
It depends on the model. 1 of 3 Washing Machine models are compatible with the Anker SOLIX C800 Plus. See the model-specific results table for exact verdicts per model.
How long will the SOLIX C800 Plus run a Washing Machine?
It depends on the model. Compatible models run approximately 0.4–0.4 hours on the SOLIX C800 Plus. 2 of 3 models are not compatible. See the model-specific results for details.
Efficiency Hack: Large appliances like the Washing Machine cycle on and off. To maximize the 0.4 hours of runtime, try to minimize how often you open the device or introduce heat loads.
Compare all 33 generators for the Washing Machine
Ranked by budget, runtime, and overall compatibility.
Technical Sourcing & Verification
ID: anker-solix-c800-plus-washing-machine 🏛️ Device Data Source
Engineering Est. Safety Factor Applied
Derived from variant list (max of variants). Running worst case = Whirlpool WTW8127LC / Maytag MVW7232HW (1296W at 10.8A). No OEM startup current published; surge modeled equal to rated draw (electronically controlled motors in all variants).
⚡ Generator Specs Source
OEM Verified
Anker SOLIX C800 Plus User Manual (EN-US)
Methodology informed by US Department of Energy (DOE) & EIA references where applicable.
Our methodology →
Compare these models
Similar-output alternatives you can compare side by side.