Voltage Gate
FAILDevice output type must match generator output.
240V required -> 120V available
No - voltage mismatch. The Well Pump (1 HP) needs 240V output, but the generator provides 120V.
Same decision gates as the engine: voltage, running, surge. Runtime is shown as operational context.
Blocking reason: voltage mismatch. Downstream gates are paused until voltage is compatible.
Device output type must match generator output.
240V required -> 120V available
Continuous draw with safety buffer applied.
Blocked by voltage mismatch.
Startup peak with safety buffer applied.
Blocked by voltage mismatch.
Runtime context only. It does not change the electrical compatibility verdict.
N/A due to voltage mismatch.
Power bars show required versus available output for each gate.
See generators that pass nativelyQuick compatibility, required headroom, and model-specific context at a glance.
0 of 3 models are SAFE or TIGHT. Most demanding model: Red Lion RL12G10-2W2V (1 HP Deep Well Submersible) (7,176W surge).
| Model | Running | Surge | Verdict | Runtime | Source |
|---|---|---|---|---|---|
| Wayne SWS100 (1 HP Shallow Well Jet Pump) | 1,840W | 5,520W | Voltage Fail | โ | NEC Standard |
Show expert analysisTechnical: **Running load:** 1840W using NEC full-load current for a 1 HP single-phase motor at 230V. **Startup surge:** 5520W estimated with a 3x motor inrush multiplier. **Voltage:** 240V required in normal US installation. Field note: Wayne publishes HP and voltage, but not FLA/LRA for SWS100. Sizing is intentionally conservative using NEC motor tables. Can a portable power station run the Wayne SWS100? Only if it provides 240V output and can handle about 1840W continuous plus a 5520W startup spike. | |||||
| Red Lion RL12G10-2W2V (1 HP Deep Well Submersible) | 2,392W | 7,176W | Voltage Fail | โ | NEC Standard |
Show expert analysisTechnical: **Running load:** 2392W from OEM voltage/current data (230V ร 10.4A). **Startup surge:** 7176W estimated at 3ร running per NEC 430.248 due to high-inrush induction motor behavior. **Voltage:** 240V required. Field note: This is the battery-killer profile in the set: high running watts plus very high startup inrush. Why does this Red Lion model fail on many power stations? Because the startup surge is very high relative to consumer inverter surge limits, even when continuous watts look close. | |||||
| Grundfos 15SQ10-220 (SQ Series Soft Start) | 1,702W | 2,553W | Voltage Fail | โ | Engineering Est. |
Show expert analysisTechnical: **Running load:** 1702W from OEM full-load amps. **Estimated startup surge:** 2553W using a 1.5x soft-start assumption. **Voltage:** 240V required. Field note: This is the generator-friendly profile in the set: still a 240V well-pump load, but with meaningfully lower startup demand. Is the Grundfos SQ easier on battery inverters than standard well pumps? Generally yes, because the SQ line uses soft-start behavior that lowers startup inrush compared with hard-start 1 HP pumps. | |||||
This unit is outside the compatible set; 4 of 33 generators pass SAFE/TIGHT for this device.
4 of 33 generators are SAFE+TIGHT for Well Pump (1 HP).
Fit class uses buffered needs (running and surge) for this device.
Rural Water Supply
Select Your Model:
This device typically needs 240V split-phase or a hardwired connection. Most portable stations are 120V-only. Verify the plug type and voltage on the device label/manual before purchase.
These systems are often hardwired to a home panel. To run them from a portable station, you may need a transfer switch installed by an electrician. You cannot just plug it in.
These generators meet Well Pump (1 HP)'s voltage, running, and surge requirements.
6000W โข 3840Wh
Lowest capacity that still clears surge + running load.
12000W โข 6144Wh
Highest available capacity for longer runtime.
Free Tools
The 6000-watt surge capacity can handle typical compressor startup loads found in central AC units, well pumps, and refrigeration equipment. The 3000-watt continuous rating can support multiple simultaneous circuits during outages. This power profile suits households requiring reliable backup for motor-driven and resistive loads without relying on fuel-based generators.
This unit uses NMC chemistry and provides 3024 watt-hours of stored energy. Source: Market Data (January 2026), not OEM-listed (listed source reference). Consumers should follow all manufacturer operating instructions and confirm compatibility with their specific appliances before deployment.
No. The Well Pump (1 HP) requires 240V output, but the Jackery Explorer 3000 Pro provides 120V only. No amount of extra wattage can fix a voltage mismatch โ you need a power source with 240V split-phase output.
No reliable runtime estimate โ this pairing is not compatible. The Jackery Explorer 3000 Pro cannot safely power the Well Pump (1 HP). See compatible alternatives above for power stations that meet this device's requirements.
Power Tip: To get the most out of your Explorer 3000 Pro, keep it in a well-ventilated area. Extreme temperatures can slightly reduce the efficiency of the LFP/NMC cells.
Compare all 33 generators for the Well Pump (1 HP)
Ranked by budget, runtime, and overall compatibility.
Derived from variant list (max of variants). Worst case = Red Lion RL12G10-2W2V (2392W running, 7176W surge).
Jackery Explorer 3000 Pro User Manual
Similar-output alternatives you can compare side by side.